gocard
Member
- Joined
- Aug 21, 2017
- Messages
- 13
- Reaction score
- 43
- Points
- 217
- Age
- 50
Offline
- Thread starter
- #1
## Changelog
## r82-hellboy-V24-beta-dirty
- [FIX] Excluded 127.0.0.1 from FAILBAN on ClusterCache, sometimes CSP Cache
was Banned.
- [ENH] Added posibility to FAILBAN for CCcam, MgCamd, Newcamd, ClusteCache, cs378x, Camd35 or as till yet for all together.
- [ENH] Only start TELNET thread when TELNET is enabled
- [ENH] Assign names to all threads started by multics to allow better troubleshooting
- [ENH] Read initial config from main proccess instead of reading it from the config thread (eliminates the need for sleep)
- [ENH] Added option -t to command line. With this option you can test your configuration files without fully starting multics. Before reporting any problem you should check you have no errors in your configuration files!!!
## r82-hellboy-V24-beta-dirty
- [FIX] Excluded 127.0.0.1 from FAILBAN on ClusterCache, sometimes CSP Cache
was Banned.- [ENH] Added posibility to FAILBAN for CCcam, MgCamd, Newcamd, ClusteCache, cs378x, Camd35 or as till yet for all together.
- [ENH] Only start TELNET thread when TELNET is enabled
- [ENH] Assign names to all threads started by multics to allow better troubleshooting
- [ENH] Read initial config from main proccess instead of reading it from the config thread (eliminates the need for sleep)
- [ENH] Added option -t to command line. With this option you can test your configuration files without fully starting multics. Before reporting any problem you should check you have no errors in your configuration files!!!